the module instructions say to use the transmitter instructions, instructions for my cub says to go to for compatible transmitters, but all they list are the spektrum and JR radios.still don't know how to bind the pro to a BNF. looking through more versions of the instructions for the pro regarding binding, says to use module binding instructions. Leave it with me and I'll do a bit of testing this evening to ensure that the DM9 (with modifications) does work with the 9XR Pro.īy the way, NEVER insert or remove the module while the transmitter is turned on!Īctually, the module has been used quite extensively, got it from a friend was his primary module. It does, however, require a couple of specific settings. As a result, the base of the antenna mast rests against the back of the transmitter case, preventing the module from fitting properly into the module bay and making proper contact with the pins.Īs a result, I've never had the DM9 in my 9XR or 9XR Pro, but I have used it in various 9X transmitters and I know the firmware works perfectly. The DM9 was not considered when the 9XR was designed - it was intended for an Orange module. My efforts to update the ERSky9x manual have been put on hold a couple of times by health problems, but I plan to return to the task shortly.Īs the pictures show, there is a problem of installation. You probably have version R212, which is a bit of a hybrid, but not too hard to figure out. To understand how the menu structure has evolved, go to: There is a full set of manuals for the original firmware (R204) at: You might want to consider upgrading to the latest stable version (R220). The manual that João and I prepared, however, is based on the new, more logical Menu structure that was introduced with version R215. ERSky9x is basically an enhanced version of ER9X. Nearly everything in the ER9X manual applies to the 9XR Pro. thanks Daedalus66 for all your suggestions i really appreciate your help. the light in the module does come on so it is installed correctly. the radio, module and plane are all brand new, never put together in any combination with any other radio/plane/nothing. I've tried the transmitter really close, and 6 feet away to bind. i tried switching it to dsm2 but that didn't work. the 9xr pro has 14 pages in setup not 11. the other half of my problem is that there is no instruction manual anywhere to be found save for that 40 page 9xr manual that doesn't really even scratch the surface of what this radio is supposed to do. the cub is a bind n fly, there is nothing i can do to it besides plug in the battery. I've tried to bind with the module NOT installed. how do i bind to my umx cub with the 9xr pro and the dm9 module? I've tried holding the bind button and powering up the radio, I've tried holding the trainer switch and power up, I've tried holding bind button and trainer switch at same time and power up. I've searched for days trying to learn how to bind. Half my problem is, my knowledge of this stuff is about 4 days worth.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |